DPI Wizard

This is added now.

These are both unsupported since there is no way of setting the sensitivity accurately. These two are added

Just added! View full update

Sensitivity can only be set in the console. View full update

Check the game notes

There's no way to set the sensitivity in this game, even with the AiO patch. Torque.ini in the game folder or under My Games gets reset on launch or does not register.

Correct!

You need to change the Multiplier 1 value to what you want to use, in most cases you can just use the same value as Mouse Horizontal Sensitivity

>The sensitivity slider is not accurate, expect some discrepancy. View full update

Scope sensitivity is added now Setting the decimals does not affect the actual FOV, even though the output shows it is set. Try to set it to 90, then 90.9 and you will see that nothing changes.

ADS is added, and I have added some additional instructions. The in-game sensitivity must be set to the default value when using the config file, and the MarkC mouse fix is highly recommended as it fixes some terrible packet drops.

Thanks for letting me know, I've updated the range now. Yes, the calculator will show you the sensitivity value below the registered minimum, unless the game has a scale that involves zero as a sensitivity. Then it will just tell you it's too low.

The calculator is not matching the 360 distance with that setup, it's matching the tracking speed: Using 360 distance might work for 1X scopes, but for anything more powerful aiming will be practically impossible. And the game does not even support such high sensitivity on the most powerful scopes. You can try it though, if you set ADS and Scope to 360 distance instead in the settings.

You don't need to request the same game multiple times

Unsupported, sensitivity is affected by frame rate.

Yes, this is correct.

Correct, but make sure you set all the sensitivity values and FOV in the game to match the calculator output. Also, depending on what your CSGO zoom sensitivity is, you might need to adjust the ADS and scope conversion setup from MDV 0%.

It's not broken, it just has a terrible range. So the only solution is to use a DPI of 500 or lower unless the devs increase the range.

Yes, you need to change the Aim Down Sight Horizontal Sensitivity value to what you use. You can usually just use the same value as for Mouse Horizontal Sensitivity.

Nice, it's updated now.

Xdefiant is already added long ago.

Unsupported due to frame rate affected sensitivity.