apex > bf5

[traeq]

When I convert my sens from apex > bf5, my scope sensitivities are way too high. I had this same issue not long ago, but somehow figured it out. I've been messing around with it for a bit now, and can't figure it out this time. 



This is what I have atm, but my apex sens is lower than it used to be, and my scope sensitivities are still higher than the old setup. 

my old settings were:
apex legends:
2.1 sens (may have been 110 fov instead of 106)

bf5 conversion:

GstInput.MouseSensitivity 0.015159
GstInput.SoldierZoomSensitivity1x00 0.395194
GstInput.SoldierZoomSensitivity1x25 0.741976
GstInput.SoldierZoomSensitivity1x50 0.730496
GstInput.SoldierZoomSensitivity2x00 0.718714
GstInput.SoldierZoomSensitivity2x50 0.713115
GstInput.SoldierZoomSensitivity3x00 0.710100
GstInput.SoldierZoomSensitivity3x50 0.708232
GstInput.SoldierZoomSensitivity4x00 0.707026
GstInput.SoldierZoomSensitivity5x00 0.705629
GstInput.SoldierZoomSensitivity6x00 0.704845
GstInput.SoldierZoomSensitivity8x00 0.704082
GstInput.SoldierZoomSensitivity10x00 0.703723


I'm not sure if I messed something up last time, or if I'm messing something up now.

Edited March 6, 2019 by traeq

[DPI Wizard]

6 hours ago, traeq said:

may have been 110 fov instead of 106

That's probably the cause of this. Everything in your conversion is based on the Apex hipfire sensitivity, so when you change the Apex FOV everything else will change too.

[TheNoobPolice]

Since you have the Apex Legends sens at 1.0, you could just turn on Uniform Soldier Aiming and set the coefficient to 0%.

No need for calculations then.