Rainbow Six - Question :P

[aKH.DD]

Hi! I'm new, I bought a subscription and I'm trying to find the right sensitivity for me. However I need help...

I used to play CS:GO on a 4:3 Stretched resolution of 1280 x 960. My sensitivity was 1.75 and DPI 400 - Screen 24 inch.

I'm now trying to play Rainbow Six but can't find the right sensitivity. Can someone help me convert it? I play on a 16:10 Aspect ratio, 1920x1080 res.

I need it converted and I can't figure out how to do it on my own; also, I want to know if the "Ironsights" represents both ironsights and holos, red dot sights and reflex sights? I'm confused as I mainly use holo and i'm not sure which category it fits in: ACOG, Ironsights or hipfire.

Thanks, Alex :]

Edited September 2, 2018 by aKH.DD
Changed sens.

[DPI Wizard]

1 hour ago, aKH.DD said:

I play on a 16:10 Aspect ratio, 1920x1080 res.

16:10 compressed to 16:9? Or do you mean 16:9? Or 1920x1200?

[aKH.DD]

No it's changed now sorry! I play rainbow six siege on 3:2 aspect ratio

[DPI Wizard]

Ok, you first need to set the FOV to the same as in CSGO, which is 58.72 in R6 if you are using 16:9 resolution as in this example. Just fill the calculator out the same way, be sure to select Hdeg Res as FOV Type for R6 and enter 90 as FOV. Then check the output for "Config FOV" for R6. For Sensitivity 1 just enter 1 as this will give you the best accuracy for the multiplier value.

For iron sight use the values from the first calculation, and use  10 for Sensitivity 2 and Monitor Distance 0% as matching method as this will make the scopes and ADS closest to each other:

Change any values here that fits your setup the best

 

[aKH.DD]

I'm currently in a match, but i will check in a minute. Thank you! I will quote your post if I need any more assistance cheers!

[aKH.DD]

14 minutes ago, DPI Wizard said:

Ok, you first need to set the FOV to the same as in CSGO, which is 58.72 in R6 if you are using 16:9 resolution as in this example. Just fill the calculator out the same way, be sure to select Hdeg Res as FOV Type for R6 and enter 90 as FOV. Then check the output for "Config FOV" for R6. For Sensitivity 1 just enter 1 as this will give you the best accuracy for the multiplier value.

For iron sight use the values from the first calculation, and use  10 for Sensitivity 2 and Monitor Distance 0% as matching method as this will make the scopes and ADS closest to each other:

Change any values here that fits your setup the best

 

So basically the iron sight is like holo sights?

[DPI Wizard]

16 minutes ago, aKH.DD said:

So basically the iron sight is like holo sights?

Yes, I've updated the description to be more clear now.