pubg PUBG: "In-game" and "Config File" values not matching + WARNING

[ayefinzherb]

Hi,

 

• "In-game" and "Config File" values not matching:

If you follow the "In-game" method and check your "GameuserSettings.ini" after closing the game,
the "LastConvertedSensitivity" value does not match with the one the calculator gives us:

Calculations:

"GameUserSettings.ini" values after following the in-game method:

 

• WARNING, If you use the "In-game" method:

Like it is mentioned in the notes: you must not press "ENTER" but click "APPLY" once you have copied your sensitivity in-game.

HOWEVER: If you close your game, the next times you'll open it and go under the "CONTROL" tab, the "APPLY" button will already be clickable even though you did not modified anything.
At this moment, clicking "APPLY" will automatically round all the values to the nearest whole number for ALL your sensitivities, just as if you pressed "ENTER" after copying them.

This means if you closed your game after following the "In-game" method, you'll have to re-enter all your sensitivities whenever you click "APPLY" in the in-game "CONTROL" tab.

 

Best regards.

Edited June 27, 2018 by ayefinzherb

[iBerggman]

Doesn't the same rounding also happen if you set it in the config, I seem to remember that it does?

 

[DPI Wizard]

28 minutes ago, iBerggman said:

Doesn't the same rounding also happen if you set it in the config, I seem to remember that it does?

Is, the values can be change slightly by the game even when set directly in the config file.

This rounding error is negligible though, the difference in the example is about 0.03 inches/360.

And the error is actually in the game, the calculator produces the correct numbers but the game messes it up.